Description

DIP Switch

Number	Function	Description
1	Slow Start Function	OFF-enable; ON-disable. Default OFF
2	Limit Mode Switching	OFF-normally open limit; ON-normally closed limit. Default OFF, used with motor limit status, not recommended to be modified by the user
3	Automatic Close Time	Automatic close time setting: the gate is operated to open by remote control operation and will close automatically after a few seconds delay. 3 OFF 4 ON: automatic close delay time is 12s. 3 ON 4 OFF: automatic close delay time is 24s. 3 ON 4 ON: automatic close delay time is 36s. 3 OFF 4 OFF: no automatic close function. Default setting: 3 OFF 4 OFF Disable the automatic close function.
4	Automatic Close Time
5	Auto-reverse Function	OFF-enable ON-disable Default position is OFF, this should align with the opener status and is not recommended to be modified by the users.
6	Remote Channel	OFF - Single channel ON - Three channels

Potentiometer Adjustment

All changes to these settings must be completed by a licensed electrician.

product-1188-387

VR1: Stall Force Mode

Maximum = More Force = Less sensitive

Minimum = Less Force = More sensitive

When Stall Force Mode is enabled (Dip switch 5 is at OFF position), the gate opener will detect obstacles and impacts to the gate. If this is during opening, the gate will stop, if this is during closing the gate will stop, and then re-open. Rotate VR1 clockwise to increase the stall force, anti-clockwise to decrease.

For safety, we strongly recommend that Stall Force Mode is left enabled (Dip switch 5 is at the OFF position). Do not turn Dip switch 5 to the ON position.

VR2: Brake Force Adjustment

For adjusting brake force at the limit position during gate opening and closing. This should only be adjusted for heavy gates that need additional force to brake when limit switch is detected.

Rotate VR2 clockwise to increase, counter-clockwise to decrease. Default setting is at minimum.

VR3: Slow Stop Width Adjustment

This switch controls how many seconds the gate opener operates at maximum speed. Rotate VR3 clockwise to increase, rotate counter-clockwise to reduce.

When VR3 switches to minimum, slow start/stop function is disable.

VR4: Motor Output Force Adjustment

For best performance, set the torque at the lowest setting for secure use.

Rotate clockwise to increase, counter-clockwise to decrease.

Default setting is at maximum.

Terminal Instructions

J1 Terminal

PE: Earth (yellow/green wire).

L: Power (brown wire).

N: Power (blue wire).

J2 Terminal

MOT1: Motor Terminal, swap with MOT2 to change gate moving direction.

MOT2: Motor Terminal, swap with MOT1 to change gate moving direction.

MOTCOM: Motor Common Terminal.

LAMP (L&N): Connection for warning lamp.

PE: Motor and warning lamp earth

Note: If require to change the moving direction, not only MOT1 and MOT2 wires need to be swapped, but also the wires of 10 and 12 on J5 Terminal have to be swapped with each other.

J3 Terminal

Motor Capacitor

J6 Terminal: Port 13 and Port 14 output door closing in place feedback signals.

J5Terminal: Limit Switch and Accessories

Additional accessories sold separately

Port 12：Open Limit Switch

Port 11：Limit Switch Common Port

Port 10：Close Limit Switch

Port 9：Ground/Earth (GND)

Port 8：Photocell input (N.C.). If no photocell is fitted, use a jumper between Ports 8 & 9.

Port 7：Power supply for accessories (+15V)

J4 Terminal: (as per Figure 18)