Terminal Instructions
X7 Terminal (as per Figure 14):
ANT: Extra Antenna
GND: Extra Antenna Shield
COM: Common Terminal for External Push Button
STP: External Stop Push Button Switch
PED: External Close Push Button Switch
OSC: External Open Push Button Switch
X5 Terminal:
SIG: Output close signal after gate closed in place.
OPLM: Open Limit Switch(Red)
COM: Limit Switch Common Terminal.
CLLM: Close Limit Switch(Green)
JP4 Straight Pin:
ON: Enable Buzzer OFF: Disable Buzzer
Note: Default setting is ON.
To enable buzzer, please go to setting "other menu" on the control board to enable it first, then put the jumper on ON.
X6 Terminal:
IR: Photocell Input Common Terminal for Photocell(N.C.)
GND: Ground
12V: Additional Accessories +12VDC, after gate closed in place, the board will enter into low power consumption mode, this terminal will cut off the 12V power supply.
LAMP+: Alarm Lamp Output +24VDC
LAMP-: Alarm Lamp Output -24VDC
Both 12V and 24V can be connected to this terminal. To connect with a 12V lamp, will work in blink; To connect with a 24V lamp, will work in steady on.
X2 Terminal and Straight Pins:
JP2 Straight Pin: The jump wire on this pin is for switching the battery type to be connected to the motor.
JP1 Straight Pin:
Has jump wire on this pin:mains power will charge the battery, the power consumption is high;
No jump wire on this pin: only for motor runs 100% against solar power, the power consumption is low.
X2 Terminal:
Jump wire on 24V, it can connect with 24V lithium battery;
Jump wire on 12V, it can connect with 12V lithium battery;
Note: + and - must be wired correctly, wrong wring will damage the control board.
X1 Terminal:
Power: Power Supply(Transformer Output)
Transformer Specification: 240VAC/22VAC or 120VAC/22VAC
Rated Power: 120W
Hot Tags: gasl800dc(dc sliding motor control board), China gasl800dc(dc sliding motor control board) manufacturers, suppliers, factory, 0 5m Nylon Gear Rack, DE01 Touch Sensor Switch, Limit Stopper, Photocell IR15 , Photocell IR17 , WIFI Module For TUYA System
