Terminal Instructions
X7 Terminal: (as per Figure 20):
ANT: Extra Antenna
GND: Extra Antenna Shield
COM: Common Terminal for External Push Button
STP: External Stop Push Button Switch
PED: External Close Push Button Switch
OSC: External Open Push Button Switch
X5 Terminal:
IR: Photocell Input Common Terminal for Photocell(N.C.)
GND: Ground
12V: Additional Accessories +12VDC, after gate closed in place, the board will enter into low power consumption mode, this terminal will cut off the 12V power supply.
LAMP+: Alarm Lamp +12/24VDC
LAMP-: Alarm Lamp -12/24VDC
JP3 Terminal:
Turn on the buzzer when the jumper cap is inserted into the ON end, and turn off the buzzer when the jumper cap is inserted into the OFF end.
Note:When the buzzer needs to be turned on, it is necessary to operate the control board to enter the "Other Menu" mode, turn on the buzzer function, and then plug the jumper cap into the ON end. At this time, the buzzer function can be used normally.
X6 Terminal:
SIG: Output close signal after gate closed in place.
OPLM: Open Limit Switch(Red Wire).
COM: Ground(White Wire).
CLLM: Close Limit Switch(Green Wire).
X4 Terminal:
24VBAT+: Battery Positive
24VBAT-: Battery Negative
Battery Specification: 24V/9Ah
12VBAT+: Battery Positive
12VBAT-: Battery Negative
Battery Specification: 12V/9Ah
Note: + and - must be wired correctly, wrong wring will damage the control board.
X2 Terminal:
Power: Power Supply(Transformer Output)
Transformer Specification: 240VAC/22VAC or 120VAC/22VAC
Rated Power: 120W
Hot Tags: sl500dc v3.3, China sl500dc v3.3 manufacturers, suppliers, factory, automatic gate opener parts, IR01S Photocell, RCV03 External Receiver, RT11, RT48, RT57
